Abstract
Silicon needles or micro wires have been produced using galvanostatic electrochemical etching and chemical over etching respectively. A 6 inch p-type (100) silicon wafer with resistivity 15-24 Ω cm and aluminum on the back side was used as starting material. Chemical over etching was performed in two steps: first, a treatment for passivating the surface of Si using an aqueous solution of polyethylene glycol and second, the Si needles were transferred immediately into the etchant which is an aqueous solution containg PEG and potassium hydroxide (KOH) pellets. The effect of varying the deposition parameters for electroless Cu deposition on silicon microwires is the main focus of this work. The bath solutions used for electroless Cu deposition were varied according to bath composition and composition concentration and additives.
Publication Details
JETIR
59
Microwires
chemical overethcing
Electroless deposition
passivation
Quick Details
Year2024
TypeJournal Article
DirectorateMaterials Science and Engineering
Share